Vacuum infusion molding
Vacuum infusion is a technique used in the nautical industry, wind energy... This process allows the mass production of large parts (airplane, windmill, boat hull...). Vacuum infusion molding consists in putting under vacuum, in a mold closed by a tarpaulin, dry reinforcements which are impregnated with resin which is sucked by the depression created in the mold.
The advantages
Improve the resistance of the composite
Saves weight
Use of just the right amount of resin (better strength to weight ratio)
Production of large and small parts in one-shot
Subcategories
Filter By
Filter By
Vacuum infusion molding
Vacuum infusion is a technique used in the nautical industry, wind energy... This process allows the mass production of large parts (airplane, windmill, boat hull...). Vacuum infusion molding consists in putting under vacuum, in a mold closed by a tarpaulin, dry reinforcements which are impregnated with resin which is sucked by the depression created in the mold.
The advantages
Improve the resistance of the composite
Saves weight
Use of just the right amount of resin (better strength to weight ratio)
Production of large and small parts in one-shot
Subcategories
Filter By
Microporous vacuum line for fast air, width 300mm 150°c
Microporous vacuum line for fast air, width 300mm 150°c
€16.01
(VAT incl.)
On order. Delay of about 3 to 4 weeks.0 produit(s)
Microporous vacuum line for fast airwidth 300mm 150°c
Microporous vacuum line for fast air, width 150mm 150°c
Microporous vacuum line for fast air, width 150mm 150°c
€7.75
(VAT incl.)
On order. Delay of about 3 to 4 weeks.0 produit(s)
Microporous vacuum line for fast airwidth 150mm 150°c
Polyethylene vacuum infusion inlet block. 16mm diameter x 35mm high. Maximum use: 100°c
Polyethylene vacuum infusion inlet block. 16mm diameter x 35mm high. Maximum use: 100°c
€2.54
(VAT incl.)
In stock35 produit(s)
Polyethylene vacuum infusion inlet block.
16mm diameter x 35mm high.
Maximum use: 100°c