Vacuum infusion molding
Vacuum infusion is a technique used in the nautical industry, wind energy... This process allows the mass production of large parts (airplane, windmill, boat hull...). Vacuum infusion molding consists in putting under vacuum, in a mold closed by a tarpaulin, dry reinforcements which are impregnated with resin which is sucked by the depression created in the mold.
The advantages
Improve the resistance of the composite
Saves weight
Use of just the right amount of resin (better strength to weight ratio)
Production of large and small parts in one-shot
Subcategories
Filter By
Filter By
Vacuum infusion molding
Vacuum infusion is a technique used in the nautical industry, wind energy... This process allows the mass production of large parts (airplane, windmill, boat hull...). Vacuum infusion molding consists in putting under vacuum, in a mold closed by a tarpaulin, dry reinforcements which are impregnated with resin which is sucked by the depression created in the mold.
The advantages
Improve the resistance of the composite
Saves weight
Use of just the right amount of resin (better strength to weight ratio)
Production of large and small parts in one-shot
Subcategories
Filter By
Polyethylene T-connector for vacuum infusion. Max: 100°C. Diameter: 18mm. PRO-VAC /10U
Polyethylene T-connector for vacuum infusion. Max: 100°C. Diameter: 18mm. PRO-VAC /10U
€0.49
(VAT incl.)
On order. Delay of about 3 to 4 weeks.0 produit(s)
Polyethylene T-connector for vacuum infusion. PVT-18Materials: PE (polyethylene)Diameter: 18 mmMaximum operating temperature: 100°C
L-shaped connector for polyethylene input blocks, diameter 18mm, up to 100°c
L-shaped connector for polyethylene input blocks, diameter 18mm, up to 100°c
€1.02
(VAT incl.)
In stock103 produit(s)
L-connector for polyethylene inlet blockdiameter18mmmaximum temperature of use of the connector up to 100°c
To be used with the polyethylene infusion inlet block (REF: PRO46261)
L-connector for polyethylene input blocks, diameter 12mm, up to 100°c
L-connector for polyethylene input blocks, diameter 12mm, up to 100°c
€1.00
(VAT incl.)
In stock43 produit(s)
L-shaped connector for polyethylene input blocksdiameter12mmup to 100°c
To be used with the polyethylene infusion inlet block (REF: PRO46261)
Polyethylene T-connector for vacuum infusion. Max: 100°C. Diameter: 10mm. PRO-VAC
Polyethylene T-connector for vacuum infusion. Max: 100°C. Diameter: 10mm. PRO-VAC
€0.36
(VAT incl.)
In stock57 produit(s)
Polyethylene T-connector for vacuum infusion. PVT-10Materials: PE (polyethylene)Diameter: 10 mmMaximum operating temperature: 100°C
Vacuum hose, ⌀13mm, 60°C
Vacuum hose, ⌀19mm, 60°C
Vacuum hose, ⌀19mm, 60°C
€3.31
(VAT incl.)
On order. Delay of about 3 to 4 weeks.0 produit(s)
Vacuum hose reinforced in PVC