Polyester peel ply for composite treatments. Maximum temperature of use: 210°C. Width: 20cm. 85g/m²
Polyester peel ply
Designed for composite treatments and hand lay-up processes for infusion.
Leaves a finish that facilitates sanding.
200mm x 100ml
The tear-off cloth allows you to remove the amine-contaminated resin layer. When you resume your work, you simply tear off the cloth instead of sanding it again and pick up where you left off. By tearing off the stripping cloth you remove the polluting solvents.
85g/m² heat-set polyester tear-off fabric.
Has a red tracer as a visible indicator to reduce the possibility of leaving a peeling layer.
The fabric leaves a finish that can facilitate sanding.
Maximum operating temperature: 180°c
We do not recommend the use of this product with phenolic resins.
It is recommended to store the tear-off tissues in a cool and dry environment. Recommended storage temperature is between 10 and 30°C and relative humidity between 50 and 75%. The peel ply should remain in the packaging until it is used.
Data sheet
- Width
- 20 cm
- Weight/m²
- 85g/m²
- Matter
- Polyester
- Max. operating temperature
- 180°C
- Special fabrics and films
- Polyester tear-off fabrics