Hardener for special coating 207C. Application of fiberglass coatings and fabrics. Gluing and laminating. 7,2Kg

Hardener 207 has been formulated for use with WEST SYSTEM 105 resin for applications where an extremely clear finish is desired.

When mixed with 105 epoxy resin, 207 hardener will not redden or cloud in wet conditions.

Thin film applications spread and remove smoothly, requiring less sanding to prepare topcoats.

This hardener provides excellent adhesion properties for bonding applications.

It contains an ultraviolet inhibitor that protects the 105/207 mixture from sunlight.

Three or more coats can be applied in one day without additional surface preparation.

Fewer coats are needed to fill the fiberglass weave and, in most cases, the final coating can be sanded the next day. Boats can be built more quickly.

However, the cured epoxy surface still requires the long-term UV protection of a quality marine paint or a two-component UV filter varnish.

Pot life at 25°C: 20 to 30 minutes

Cure to solid at 21°C : 9 to 12 hours

Curing to maximum strength at 21°C : 5 to 7 days

Minimum recommended working temperature: 16°C

Consumption:

- for a 1kg mixture on a porous surface at 25°C: 7 - 8 m².

- for a 1kg mixture on a non-porous surface at 25°C : 9 - 10 m².

Attention: For each resin can size, there is a corresponding hardener can size and mini pump size. Make sure that all cans and pumps have the same letter (A, B, C or D). If you have any doubts, please contact our customer service.

Dosing: The mini-pumps allow you to pour the exact proportions of resin and hardener. In order to have correct proportions, it is enough to make one pressure of resin for one pressure of hardener.

Mixing: Mix the resin and hardener for two minutes or longer at low temperatures. Scrape down the sides and bottom of the pot while mixing.

How to dose and mix your epoxy?

Product Selection Guide

Demonstration video on basic, advanced, repair techniques

Dosing and mixing demonstration video